Snell Wilcox IQSRT10
The Snell Wilcox IQSRT10 is an eight-input router/switcher for HD-SDI 1.5 Gbit/s, SD-SDI 270 Mbit/s, DVB-ASI and wide-band signals.
This connector allows you to manage this device using a smart-serial connection.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device, e.g., 10.253.112.83.
- IP port: The IP port of the device, e.g., 2050.
- Bus address: The unit address and the unit port, e.g., 10.10 (for unit address 0x10 and unit port 0x10).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
Usage
The element created with this connector consists of the following data pages:
- General: Contains the Display parameter and gives an overview of device properties such as Version, Build, Serial and Firmware. Also contains buttons that allow you to do a Restart and a Factory Reset.
- Crosspoint: Allows you to set up the input/output routing by changing the source and destination channels. You can also enable the changes to the routing matrix on the template without actually configuring the crosspoint until the Take button is pressed. There are four buttons that allow different Take configurations.
- Output 1/2 Switching: These pages allow you to set up the switching parameters for output 1 and 2 by setting the Synchronous State, Force RP168, Output Line and Pixel.
- Name Association: Allows you to name the inputs and shows the state for each input.
- Memory 1-16: Allows you to define a number of setups of the IQSRT10 to be saved and recalled. Via page button, you can access the configuration for memories 9 to 16.
- Logging: Check the appropriate box to see information about various parameters on this page.
- RollTrack: Allows you to send information to other compatible units connected on the same networks, using the Source, Address and Command parameters.
- GPIO: Allows you to configure the GPI functions.
- GPIO Debug: When selected, the debug settings will take priority over the setup options and the setup options will be grayed out.