Snell Wilcox KudosPro Frame
This connector was designed to interface with the KudosPro and provide the features found in the RollCall Control Panel.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.5D.10 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
IP Connection
This connector uses a serial connection and requires the following input during element creation:
Serial connection:
- IP address/host: The polling IP of the device, e.g., 172.16.61.11.
- IP Port: The IP port of the device, e.g., 2050.
- Bus address: Fill in the unit address and port. For example, if 26.02 is filled in, this represents the unit address 0x26 and unit port 0x02.
How to use
You can find more information about the different data pages of the element below.
General
The General page provides information related to the status of the device.
Genlock
On the Genlock page, you can view and adjust source and timing parameters for channels 1 and 2.
Audio Routing
On the Audio Routing page, you can view and adjust the routing for the AES and analog outputs.
Audio Control
On the Audio Control page, you can view and adjust the unit's input and output audio handling options.
Dolby Page
On the Dolby page, you can view and adjust the unit's Dolby parameters.
Network Page
The Network page provides access to the unit's network details and setup.
When you update the IP Address, IP Gateway, IP Netmask, or IP Configuration parameters, click the Apply IP Changes button to ensure that the updated parameters are properly saved to the unit's configuration.
Front Panel Page
On the Front Panel page, you can view and adjust the front panel features such as LCD Display and Headphone parameters.
Memories
The Memories page allows you to save up to eight system-level memory setups and recall them when required.
The options Reset to Defaults and Factory Reset are also available. Use these with caution, as they will reset previously configured parameters.
Logging
The Logging page displays how the parameters will be displayed when made available to the logging device.
The Logging Config subpage allows you to configure which parameters are available to the logging device.