Snell Wilcox UKON
This connector is used to poll and edit configuration information from a Snell & Wilcox UKON device.
About
The communication is based on a serial protocol implemented by the device (RollCall protocol). As the element has to receive unsolicited messages, its type is "smart-serial".
The element uses 2 interfaces for a redundant polling: if connection is lost on one of the interfaces, the polling is automatically switched over to the other one.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | All |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
IP address/host: The polling IP of the device/serial gateway (e.g., 127.0.0.1)
IP port: The IP port of the device/serial gateway (required, e.g., 7000)
Bus address: The bus address of the device/serial gateway (required, e.g., 1.1.1, <Network Address Used For Bridging>.<Unit Address>.<Port Address>)
Usage
Audio
On this page, you can find audio parameters such as O/P 1 Source, O/P 3/4, Digital Audio Delay Mode, Individual O/P 4, ...
Convert
Here are displayed the convert parameters: Input Type, Output Sense, Bias, ...
The Free Run... page button gives the Flag Delay, Reset Type, ... and the Video... page button the following parameters: Video Aperture, Blur, ...
Display
This part concerns the display parameters: Transition Type, Transition Shape, Update Rate, Var Tilt, ...
Information
The available parameters are: Unit Status, Unit Input Standard, Unit Output Standard.
Input
Here are shown the Input parameters: Input Std, Input Active Top, Matrix Colorimetry, Input A/B, ...
Memory
You can select the memory to use with the Use Memory parameter and set another name with the Rename parameter.
Output
Here you can edit the Output parameters such as the Output Std, Clipper or the Output Colorimetry.
In the Enhancer... page button, following parameters, among others, can be edited: Horz Enh Band, Vertical Enh Y+C, ...
In the Processing Amplifier... page button, you can adjust parameters such as Gain Master, Gain Y, Offset Master, Offset Y, ...
In the Border... page button, you can edit the following parameters: Border Enable, Border Red, Border Green, Border Blue, Full Color, ...
Reference
This page allows to configure the reference through these parameters: Reference Enable, Ext Reference Std., Reference Source, Horizontal Timing, Vertical Timing, ...
Session Information
The Session Status indicates in which phase is the communication process with the device (initialization or normal communication),
Setup
Modification of Setup Info or GPI Status is possible.
In the RollCall... page button, these parameters are available, inter alia: Sys Name, Input Status, Output Standard, Picture, ...
Timecode
On this page, time parameter are editable: Trigger Hour, Trigger Frame, Synchronization, Manual Minutes, ...
Utils
Finally, in the Utils page, you can modify, for example, the Utils Pattern, the Mono Enable or the YC-Delay.