Table of Contents

Sonifex RB-SD1IP

The Sonifex RB-SD1IP silence detection unit is an upgraded version of the existing RB-SD1.

The unit is a 1U rack mount device used to monitor an unattended stereo studio feed. In the event of the signal going "quiet", after a given period the unit will switch to an alternative stereo audio signal.

About

Version Info

Range Key Features Based on System Impact
1.0.0.x Initial version - -

Product Info

Range Supported Firmware
1.0.0.x v1_19

System Info

Range DCF Integration Cassandra Compliant Linked Components Exported Components
1.0.0.x No Yes - -

Configuration

Connections

SNMP Connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device.
  • Device address: This is not required.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string used when reading values from the device (default: public).
  • Set community string: The community string used when setting values on the device (default: private).

Usage

General

This page displays the Firmware Version, GPI States, Output Left/Right Sources and Input Alarm States. There are also page buttons for Signal Levels and Silence Levels.

Configuration

This page displays the Source Select, Mode Select, Restore, Global Silence Detect of Two Minutes and Force Output.

Web Interface

This page provides access to the web interface of the Sonifex RB-SD1IP unit. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.

Improve this page