SonoVTS UHD Monitor HDQ-Line
This device is a multi-monitor controller with support for UHD broadcasting.
About
This connector allows you to monitor the parameters of the media stream connected to the device. This connector implements the Ember+ protocol to fetch the relevant information from the device.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | V0.9022 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Smart-serial Main Connection
This connector uses a serial-over-IP connection implementing the Ember+ protocol, and requires the following input during element creation:
SMART-SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device. By default, this value is 9000.
Usage
General
This page provides information about system variables such as the firmware version, device name, serial number and equipment type. It also allows you to set the standby and exit modes of the device.
A subsection of this page provides basic networking information, such as the IP address, netmask, MAC address and gateway.
Overlay
This page shows the input type and the graphic layer. It also provides access to three subsections: Audio Bar Settings, Overlay Settings and Safe Frame. These subsections contain tables to configure UMD, Tally and Safe Layer options.
Picture Settings
This page contains information about the properties of the image that is being broadcast. Most of these properties are read-only. The parameters on this page include among others Backlight, Brightness, Deinterlacing, Color Space, Range, Aspect and Gain Backlift (configurable).
DataMiner Connectivity Framework
This connector supports DCF connections since version 1.0.0.2 and requires a DMA with at least DataMiner version 9.0.0.5.
DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).
Interfaces
Fixed Interfaces
There is a single input (parameter Selected Input) that is available through DCF.