Sony CNA-1 - CCU
The CNA-1 camera control network adaptor enables third-party system products to control Sony system cameras over IP networks. CNA-1 works as a protocol converter, translating the original 700PTP protocol of Sony cameras to and from Simple Protocol to allow the cameras to work easily with third-party devices.
About
This connector is automatically generated by the connector Sony CNA-1, range 1.0.0.x.
The Sony CNA-1 - CCU connector can be used to display information related to each RCP reported by the main element running the Sony CNA-1 connector.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Unknown |
Configuration
Initialization
This connector is used by DVEs that are automatically created by the parent element. No user input is required.
Redundancy
There is no redundancy defined.
How to use
General
This page displays information related to the CCU, such as the model, serial number, Status (Available or Not Available) and Camera Status (Available or Not Available).
CCU Settings
This page contains the CCU Settings, such as System Frequency, Available Transmission Formats, Transmission Format and Gen lock Mode.
NMI
This page allows you to connect this CCU to the selected NMI. Note: only 1 NMI element can be connected to 1 CNA CCU. You can check which NMI element is connected to which CCU via the NMI table on the main element.