Sony RCP-3000 Series
The Sony RCP-3000 Series enables the monitoring of remote control panels for Sony HDC/HSC/HXC series cameras. This connector executes queries via Ember+ to retrieve this data.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.30 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
IP Connection
This connector uses a smart-serial connection and requires the following input during element creation.
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 9000).
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to Use
Ember+ calls are used to retrieve the device information, which is then displayed on the General page of the element.
On the Configuration subpage, you can configure after how much time the connector should enter timeout state if no data is received from the device.