Specialty Microwave Corp 11464-507
This connector uses serial communication to communicate with a switching module. This module powers to up to four low-noise amplifiers (LNB) and provides redundancy protection switching logic for the LNBs.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, e.g., 9600.
- Databits: Databits specified in the manual of the device, e.g., 7.
- Stopbits: Stopbits specified in the manual of the device, e.g., 1.
- Parity: Parity specified in the manual of the device, e.g., No.
- FlowControl: FlowControl specified in the manual of the device, e.g., No.
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device. Default: 49. Range: 33 - 126.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
On the General page, you can find the information retrieved by the connector, such as the Operation State of the Power Switches, the Switches, and the LNBs.
You can also change the Switch Positions and set the Unit State.