Specialty Microwave Corp 11845-500
The Specialty Microwave Corp 11845-500 connector retrieves the power supply and switch position through a serial connection.
The Antenna Switching Panel, Part No. 11845-500, consists of a logic panel used in satellite communication earth stations. The system mechanism operates waveguide/coaxial switches to operator desired positions.
About
This connector is designed to work with the Antenna Switching Panel, Part No. 11845-500. Using a serial connection, the connector sends a single command that requests the status of the power supplies and the position of the switches. Polling occurs every ten seconds.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Information about the device firmware is currently unavailable. The current implementation is based on Revision 0 of the device's documentation. |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Installation and configuration
Creation
Main connection
This connector uses a serial connection and requires the following input during element creation:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device. The value has a range of 0 to 255 (default: 49).
Usage
This connector has one page.
General
At the top of this page, information is displayed regarding the status of the device, such as the first and second power supply status (Power Supply 1/2 Status) and the Communication Status of the serial connection.
Below, the status of the switches (Switch 23/24/25/26/27/28/29/30/31/32 Status) is displayed, which indicates the position of each switch (Position 1, Position 2, or NA)