Specialty Microwave Corp 4360A-xxx

This device is a 1:1 protection switch for HPA switching. It is a manual and automatic controller for a 1:1 high-power waveguide switching mechanism used in satellite communication earth stations.

About

This connector use a serial connection to communicate with the device.

Version Info

Range	Description	DCF Integration	Cassandra Compliant
1.0.0.x [SLC Main]	Initial version	No	Yes

Product Info

Range	Supported Firmware Version
1.0.0.x	--

Installation and configuration

Creation

Serial Main Connection

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• Direct connection:

  • Baudrate: Baudrate specified in the manual of the device, e.g., 9600.
  • Databits: Databits specified in the manual of the device, e.g., 7.
  • Stopbits: Stopbits specified in the manual of the device, e.g., 1.
  • Parity: Parity specified in the manual of the device*.*
  • FlowControl: FlowControl specified in the manual of the device*.*

• Interface connection:

  • IP address/host: The polling IP of the device.
  • IP port: The IP port of the device.
  • Bus address: The bus address of the device. Default value: 49. Range: 33 to 127.

Usage

General

This page displays general device parameters, such as:

• Switch Position
• Switch Mode
• Remote Mode
• Summary Fail 1Status
• Summary Fail 2Status
• Power Supply 1 Status
• Power Supply 2 Status