Spectracom Epsilon GPS Clock EC22S
This connector is used to monitor and control a Spectracom Epsilon GPS Clock EC22S.
About
Epsilon Clocks provide accurate and stable time and frequency signals for your high-performance synchronization application. The unit's architecture is well-suited to transmitter synchronization of digital broadcast signals (DVB-T/T2, T-DMB, DAB or DRM) in Single Frequency Network (SFN) modes: the high port density allows the simultaneous synchronization of many emitters on the same site.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | debian40 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g. 172.32.65.38.
SNMP Settings:
- Port number: The UDP port, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
Base Unit
This page displays status and control parameters for the base unit.
Clock
This page displays status parameters for the Left Clock and Right Clock. At the bottom of the page, Clock Control parameters can be set.