Stagetec Montone
The Stagetec Montone connector can be used to display, configure and monitor the in- and output streams.
About
There are two serial connections that are used to retrieve the necessary information from the device.
The connector features DCF integration but does not use any internal DCF logic.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | Yes | Yes | - | - |
Installation and configuration
Creation
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device.
- Databits: Databits specified in the manual of the device.
- Stopbits: Stopbits specified in the manual of the device.
- Parity: Parity specified in the manual of the device.
- FlowControl: FlowControl specified in the manual of the device.
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Serial IP Port 2 Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device.
- Databits: Databits specified in the manual of the device.
- Stopbits: Stopbits specified in the manual of the device.
- Parity: Parity specified in the manual of the device.
- FlowControl: FlowControl specified in the manual of the device.
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage
General
This page contains general information about the device and the two interfaces.
Advanced
This page allows you to configure advanced settings on the device.
Two buttons at the bottom of the page open the Network Settings and the PTP Clock Settings, respectively.
Statistics
This page contains the Packet Lost table, which displays the packet loss for each protocol.
Inputs
This page displays the Input Stream table, which lists all 32 streams with all the relevant information.
Outputs
This page contains the Output Stream table, which lists all 32 streams.
Web Interface
This page provides access to the web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.