Symmetricom TSC 4036B
The 4036B provides fifteen outputs from a single input for distributing RF signals in laboratory, factory, and test and measurement environments where low phase noise and high channel isolation are required. The 4036B is a 1-input, 15-output RF distribution amplifier in a 1U chassis that provides fifteen isolated copies of a single input.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
IP Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 10001).
Initialization
No additional configuration is required.
Redundancy
There is no redundancy defined.
How to use
You can find all the information needed to monitor the 4036B on the General data page, including the Input Frequency, Model Number, Software Version, Input Signal State and Outputs State Alarm Table.