Systembase C310xr
About
This connector is used to monitor and configure the C310xr codec from Systembase.
The connector displays information about the different patches in a table and in a tree view. It is possible to disable some of the patches, so that the communication traffic over the network is kept to an absolute minimum.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.1 | Initial version. | No | Yes |
| 1.0.0.2 | Renamed ISDN 1 to Channel 1 and ISDN 2 to Channel 2. Added extra ISDN status values. Fixed remote addresses starting with 0. Reduced polling rate. | No | Yes |
Installation and configuration
Creation
Serial Main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The serial number of the device. This is necessary to establish communication with the device.
Usage
Overview
This page displays information about the patches in a tree view.
The refresh button next to the tree view allows you to refresh all patches for which the polling state is enabled.
Configuration Table
This page displays information about the patches in a table.
The refresh button next to the table allows you to refresh all patches for which the polling state is enabled.