Table of Contents

Tandberg SM6620

The Tandberg SM6620 connector can be used to display and configure information via SNMP.

About

The SM6620 modulator provides a feature-rich modulation solution while maintaining ease of use and control.

Installation and configuration

Creation

This connector uses an SNMP connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the SM6620 Modulator, e.g., 10.11.12.13.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General Page

This page contains general parameters, together with the alarms status and current alarm table.

Modulator

This page contains configuration parameters of the modulator.

Webpage

The webpage of the device.

Improve this page