Tandberg TT4030 HTTP

The TANDBERG TT4000 range of Transport Stream monitors combine advanced error detection and monitoring via a web interface in a 3RU multi-channel unit.

About

The Tandberg TT4030 HTTP connector is used to monitor a Tandberg TT4030 device. The information is divided in several categories that are displayed in different pages. The connector uses HTTP to communicate with the device.

Installation and configuration

Creation

This connector uses a Serial connection and requires the following input during element creation:

SERIAL CONNECTION:

- IP address/host: The polling IP of the device, e.g., 10.11.12.13.

- IP port: The port of the connected device, e.g., 80.

- Bus address: The bus address of the connected device: not defined.

Usage

TS Info page

The TS Info page displays the general information of the transport stream.

ERT290 Info page

This page displays the information for the three priorities.

Service Info Page

The Service Info page displays the Service Info table. In this table, the different services are displayed. Once services are no longer available, these rows can be removed manually by clicking the Clear Services button. They can also be removed automatically by setting the Auto Clear Services parameter to Enabled.

The Normalize CA. page button opens a pop-up page where, when the Normalize button is pressed, the user can see the Service Info CA Normalization table.

PID Info Page

On this page, the PID Info table can be seen. If PIDs are no longer available, these rows can be removed manually by clicking the Clear PIDs button. They can also be removed automatically by setting the Auto Clear PIDs parameter to Enabled.

Web Interface Page

Here the user can see the web interface of the device.

Notes

It is recommended to set the Auto Clear Services and the Auto Clear PIDs parameters to Enabled, so that all the Services and PIDs that are no longer available are removed from these tables.