TeamCast CID Receiver
With the TeamCast CID Receiver connector it is possible to configure and monitor the Carrier ID extractor DVB-S/DVB-S demodulator. This device is a satellite receiver and is used to optimize the quality of satellite links.
This optimization is achieved by embedding and detecting a small message and a unique ID within the video or data satellite carrier.
About
The product reference of this CID Receiver is CID0-1510. The CID0-1510 is used to detect the Carrier Identification of a host carrier that has embedded the DVB-CID ETSI TS 103 129 standards-based Carrier ID technology.
This connector retrieves and sets data via SNMP.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | S1100-B008 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, the default value is public.
- Set community string: The community string used when setting values on the device, the default value is private.
Usage
General
This page shows the version info and allows the user to configure ethernet, snmp and time options.
Configuration
This page allows the user to configure the RF Input options and the RF Output options.
Profile
This page shows a table containing all created profiles. Futhermore it is possible to create a new profile or delete a profile and to load/store configurations from/to a created profile.
Monitoring
This page shows the monitored parameters. These are grouped by input, process, DVB-S2 - Single Stream, DVB-S2 - Multi Stream, Output - ASI, Output - IP, Probes, Probes DVB-S, Probes DVB-S2.
TSOIP
This page allows the user to configure the TSOIP parameters. These configuration are grouped by Common Configuration and Channels Configuration.
Carrier ID
This page allows the user to enable/disable CID Extraction. Info parameters regarding the CID Extraction are also shown on this page.
Alarm
This page shows the device temperature followed by a Alarms - General table and a Alarms - Product table. Both tables show the alarm status value (ON/OFF) and alarm counter. Both tables also allow the user to configure the alarm settings. Following the alarm tables the page shows the status LEDs and the relay status. It's also possible to reset the relays from this page.
WebInterface
The web interface is meant to embed the device webUI. The address of the host/webUI has to be configured on the General page (SNMP Configuration), otherwise the web interface defaults to localhost (127.0.0.1).