TeamCast Neptune
NEPTUNE is a 1RU DVB-S2X satellite demodulator that supports all advanced DVB-S2X modes. Specifically, NEPTUNE can demodulate signals ranging from QPSK to 256 APSK and from 0.1 to 500 MBaud, offering high operational flexibility.
About
This connector for the TeamCast Neptune displays the demodulator configuration and outputs for inputs, outputs and channels.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | Yes | Yes |
| 1.0.1.x [SLC Main] | Polling manager integration | Yes | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 100 |
| 1.0.1.x | 100 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection to communicate with the device, and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The IP of the TeamCast device.
- IP port: The IP port of the destination, by default 161.
Usage
General
This page displays generic device information, as well as the status of the Startup, Hardware, Software, Loading Process, Internal Com, Fault LED, Ready LED, Software Compatibility, System Clock, Power Supplies and Fans.
In the upper right corner, you can find the Temperature of the device.
Via page buttons, you can access the following subpages:
- Network: Allows you to configure and monitor the Ethernet Control and Data interfaces.
- SNMP: Allows you to configure SNMP settings.
- Time Config: Allows you to configure the time zone and NTP information.
- Firmware Update: Displays the status of the current firmware update.
- Profiles: Allows you to configure and set profiles.
- Licenses: Displays license status information and allows you to set license keys.
Inputs
This page displays the Input RF and Input ASI configuration and status tables.
Outputs
This page displays the Output ASI, Output TSOIP, Output GSE and Output MPE configuration and status tables.
Process
This page displays information on the channels in the Channels and Channel Status tables.
The Probes Status table displays the probes for the channels and the values for the probes.
Status
This page displays the system alarm status parameters in the sections System Status, Input Status, Output Status and Process Status.
Via page buttons, you can configure the trap generation and the severity of the status parameters.
TSOIP Tx
This page displays the TSOIP Tx and TSOIP Tx Status table, which can be used to configure the TSOIP transmit.
Log
On this page, the Trap Logs table displays a log of the traps received from the device. Via the available buttons and page button, you can manipulate the table.
Polling Settings
On this page, group polling can be configured. You can either enable or disable group polling, and you can configure the polling time.
Web Interface Page
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.
DataMiner Connectivity Framework
This connector supports the usage of DCF.