Teleste HDC100 TSEMP - HDO202

The HDO202 is a dual receiver with frequency range 5 to 300 MHz and output switches for return path fibre optic links in CATV networks.

The Teleste HDC100 TSEMP - HDO202 connector can be used to display and configure information of the related device.

About

A serial connection is used in order to successfully retrieve and configure the device's information. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP range 4.0.0.X.

Product Info

Range	Supported Firmware Version
4.0.0.x	A, C, F

Installation and Configuration

A DVE using this connector is automatically created by an element using the parent connector.

Usage

Properties

This page contains the identification (Type, Configuration, Serial Number, Hardware Version, etc.) and statistics (Up Time, Reset Count, etc.) of the device.

Adjustments

This page contains the different measurements (Optical Input Power, Attenuator Status, etc.) and settings (Wavelength, Attenuator, Level Control Mode, etc.) for each input of the device.

Routing

This page contains the different routing (Routing Mode, etc.) and Power Save settings.

Monitoring

This page contains all the settings that are related to the alarm monitoring of the device:

• Alarm Control Detection
• ACD On Delay
• ACD Off Delay
• Overview of the Analog Alarm Limits
• Overview of the Discrete Alarm Limits