Teleste HDC100 TSEMP - HDO212

The HDO212 is a receiver. The Teleste HDC100 TSEMP - HDO212 connector can be used to display and configure information of the related device.

About

A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP range 3.0.0.X.

Product Info

Range	Device Firmware Version
3.1.0.x	SW Version 1.1 SW Version 1.2

Installation and configuration

Creation

A DVE using this connector is automatically created by an element using the parent connector.

Usage

General

This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, etc.).

In addition, it is possible to enable or disable the Alarm Control Detection on this page.

Optical

This page contains parameters concerning Rx 1 (A) Optical and Rx 2 (B) Optical (Power, Wavelength, Reference, Power Status Enable, etc.).

RF

This page contains the parameters Auto Mode, Attenuator, OMI/Channel, Output Level Target, etc.

Switch

This page contains the parameters Backup Status, Control Value, Routing Mode, etc.

Alarm Limits ORX212

This page displays both the Analog Alarm Limits and the Discreet Alarm Limits table.

For the analog parameters, you can configure both the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband. For the discrete parameters, the Notification can be changed.