Teleste HDC100 TSEMP - HDO302

The HDO302 is a DFB laser transmitter for return path (upstream) fiberoptic links in CATV networks. The transmitter can be installed in an HDX002 installation frame.

About

A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP range 4.0.0.x.

Product Info

Range	Supported Firmware Version
4.0.0.x	BIOS Version: 1.2

Installation and configuration

Creation

A DVE using this connector is automatically created by an element using the parent connector.

Usage

Properties

This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, etc.).

In addition, it is possible to enable or disable the Alarm Control Detection on this page.

Adjustments

The following parameters can be configured on this page: Attenuator, ALC Mode, Target OMI, RF Input Reference Level, Equalizer Control and Pilot Frequency.

The Laser Output Power Status, Laser BIAS Current and Laser BIAS Current Status can be monitored on this page.

Monitoring

This page displays both Analog Alarm Limits and Discreet Alarm Limits Tables.

Both the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband can be configured in here for the analog parameters. For the discrete parameters, the Notification can be changed.

The alarm control detection parameters can be configured as well: ACD, ACD on Delay and ACD off Delay.