Teleste HDC100 TSEMP - HDO371

The HDO371 is a DWDM DFB laser transmitter for return path (upstream) fiberoptic links in CATV networks. The transmitter can be installed in an HDX002 installation frame.

About

A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP, range 4.0.0.x.

Product Info

Range	Supported Firmware Version
4.0.0.x	BIOS Version: 1.2

Installation and configuration

Creation

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

Usage

Properties

This page contains general parameters such as DVE Name, Alias Name, Hardware Version, BIOS Version, Type, Serial Number, Slot and Rack Numbers, Fan Status, Temperature and Reset.

There is also a Refresh button that can be used to poll the data manually.

Adjustments

On this page, the following parameters can be configured: ALC Mode, Target OMI, Pilot, Attenuator, Equalizer, Pilot Frequency and RF Input Reference.

In addition, the following parameters can be monitored: Laser Output Power, Initial Factory Laser Output Power, Initial Factory Wavelength, Laser TEC Current and Initial Factory Laser BIAS Current.

Monitoring

In addition to the Analog and Discrete Alarm Limits Table, this page also contains the following alarm control detection parameters: ACD, ACD on Delay and ACD off Delay.

Status

On this page, you can monitor the status of the Laser BIAS Current, Laser TEC Current, Attenuator and Laser Output Power.