Teleste HDC100 TSEMP - HDO773
The HDO773 is a downstream transmitter that supports frequencies up to 1006 MHz and has one 10 dBm output. It is a 1550 DWDM transmitter for short, medium and long distances. It supports broadband, narrowcast and broadcast services in a digital format.
About
A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | BIOS Version: 1.2 |
Installation and configuration
Creation
A DVE using this connector is automatically created by an element using the parent connector.
Usage
Properties
This page contains general parameters such as the DVE Name, Type, Hardware Version, Serial Version, BIOS Version, Reset, Total Uptime, Temperature, Fan Status and Alias Name.
There is also a Refresh button that can be used to poll the data manually.
Adjustments
On this page, you can monitor and configure parameters specific to this module:
- Input 1 Attenuation Control
- Input 1 Slope Control
- Input 2 Slope Control
- Input 2 Attenuation Control
- Laser
- Power Save
- Adjustment Mode
- 24V
- 5V
- Laser Temperature
- Laser TEC Current
- Laser Power
- APC Measured Offset
- APC Optimum Offset
- Factory BIAS Current
- Factory Output Power
- Factory Wavelength
Monitoring
This page displays both Analog and Discrete Alarm Limits Tables, as well as the following alarm control detection parameters: ACD, ACD on Delay and ACD off Delay.
Status
On this page, you can verify the status of the Laser Temperature, Laser Power, Laser BIAS Current, Input 2 Slope Control, Input 1 Slope and Attenuation.