Teleste HDC100 TSEMP - HDO802

HDO802 is a forward path (downstream) receiver for fiberoptic links in CATV networks. It is installed in an HDX002 installation frame.

About

A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP, range 4.0.0.x.

Product Info

Range	Supported Firmware Version
4.0.0.x	BIOS Version: 1.2

Installation and configuration

Creation

A DVE using this connector is automatically created by an element using the parent connector.

Usage

Properties

This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, etc.).

In addition, it is possible to enable or disable the Alarm Control Detection on this page.

Routing

This page displays the Routing Mode, Switch Control, Backup Restore and Backup Restore Mode.

Adjustments

The following parameters can be configured on this page: Slope Control, Attenuator Control, Level Control Mode and Wavelength.

The Attenuator Status, Slope Control Status, Optical Input Power and Optical Input Power State can be monitored on this page.

Monitoring

This page displays both Analog Alarm Limits and Discreet Alarm Limits Tables.

Both the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband can be configured here for the analog parameters. For the discrete parameters, the Notification can be changed.

The alarm control detection parameters can be configured as well: ACD, ACD on Delay and ACD off Delay.