Table of Contents

Teleste HDC100 TSEMP - HDO906

The HDO906 is a directly modulated, linear O-band DWDM DFB laser transmitter for forward path fiberoptic links in CATV and FTTx networks.

The Teleste HDC100 TSEMP - HDO906 connector can be used to display and configure information of the related device.

About

A serial connection is used in order to successfully retrieve information from and apply settings on the device. Different possibilities for alarm monitoring and trending are available.

This connector is automatically generated by the connector Teleste HDC100 TSEMP, ranges 3.1.0.x and 4.0.0.x.

Product Info

Range Supported Firmware Version
3.1.0.x SW version 1.49
4.0.0.x B, F

Installation and configuration

Creation

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

Usage (Range 3.1.0.x)

General

This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, Fan Status, etc.).

In addition, it is possible to set the Alarm Control Detection parameters on this page.

Via the Alarm Limits HDO906 page button, you can access the Analog Alarm Limits and the Discrete Alarm Limits tables. For the analog parameters, you can configure the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband. For the discrete parameters, the notification can be changed.

Optical

This page contains parameters related to the Laser, such as Laser Bias Current, Laser Output Power, Laser Temperature, etc. It also contains the Initial Factory Values parameter.

RF

This page contains parameters related to Input 1 and Input 2 (State, Attenuator, Equalizer, etc.), as well as the Adjustment Mode and APC Settings parameters**.**

Usage (Range 4.0.0.x)

Properties

This page contains parameters that identify this module (Type, Configuration, Serial Number, Hardware Version, etc.) and statistics parameters (Up Time, Reset Count, etc.).

Adjustments

This page contains the different measurements (Laser Output Power, Laser Bias Current, Laser TEC Current, etc.) and settings (Adjustment Mode, Attenuator and Equalizer for both inputs, APC settings, etc.) of the device.

Monitoring

This page contains all the settings that are related to the alarm monitoring of the device:

  • Alarm Control Detection
  • ACD On Delay
  • ACD Off Delay
  • Overview of the Analog Alarm Limits
  • Overview of the Discrete Alarm Limits
Improve this page