Teleste HDC100 TSEMP - HDO907

The HDO907 is a transmitter. The Teleste HDC100 TSEMP - HDO907 connector can be used to display and configure information of the related device.

About

A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Teleste HDC100 TSEMP range 3.0.0.X.

Product Info

Range	Supported Firmware Version
3.1.0.x	SW Version 2.4

Installation and configuration

Creation

A DVE using this connector is automatically created by an element using the parent connector.

Usage

General

This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, Fan Status, etc.).

In addition, it is possible to enable or disable the Alarm Control Detection on this page.

Optical

This page contains parameters related to the Laser, such as Laser Bias Current, Laser Output Power, Laser Temperature, etc.

RF

This page contains parameters related to Input 1 and Input 2 (Status, Attenuator, Slope, etc.), as well as the ALC Mode, APC Measured Offset and Power Save parameters**.**

Alarm Limits TRM907

This page displays both the Analog Alarm Limits and the Discreet Alarm Limits table.

For the analog parameters, you can configure both the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband. For the discrete parameters, the Notification can be changed.