Teleste HDC100 TSEMP - HDO908
The HDO908 is a 1310nm DWDM transmitter for short distances. It supports broadband, narrowcast and broadcast services in a digital format. The HDO908 downstream transmitter supports frequencies up to 1218 MHz and has one 8/10/12 dBm output.
About
A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
This connector is automatically generated by the connector Teleste HDC100 TSEMP, range 3.1.0.x and 4.0.0.x.
Product Info
| Range | Supported Firmware Version |
|---|---|
| 3.1.0.x | SW version 1.12 |
| 4.0.0.x | Unknown |
Installation and configuration
Creation
This connector is used by DVEs that are automatically created by the parent element. No user input is required.
Usage (Range 3.1.0.x)
General
This page contains parameters that identify this module (Type, Serial Number, Software Version, Hardware Version, etc.) and statistics parameters (Uptime, Number of Restarts, Temperature, Fan Status, etc.).
In addition, it is possible to set the Alarm Control Detection parameters on this page.
Via the Alarm Limits HDO908 page button, you can access the Analog Alarm Limits and the Discrete Alarm Limits tables. For the analog parameters, you can configure the threshold and the status of HiHi, Hi, Lo, LoLo and Deadband. For the discrete parameters, the notification can be changed.
Optical
This page contains parameters related to the Laser, such as Output Mode, Laser Bias Current, Laser Output Power, Laser Temperature, etc. It also contains the Initial Factory Values parameter.
It is recommended to refresh the page after setting the Output Mode, since it can take some time for the values to be updated after the set.
RF
This page contains parameters related to Input 1 and Input 2 (State, Attenuator, Equalizer, etc.), as well as the Adjustment Mode and APC Settings parameters**.**
Usage (Range 4.0.0.x)
Properties
This page contains parameters that identify this module (Type, Configuration, Serial Number, Hardware Version, etc.) and statistics parameters (Up Time, Reset Count, etc.).
Adjustments
This page contains the different measurements (Laser Output Power, Laser Bias Current, Laser TEC Current, etc.) and settings (Adjustment Mode, Attenuator and Equalizer for both inputs, etc.) of the device.
Status
This page displays status parameters related to the laser parameters.
Monitoring
This page contains all the settings that are related to the alarm monitoring of the device:
- Overview of the Analog Alarm Limits
- Overview of the Discrete Alarm Limits
- Alarm Control Detection parameters