Teleste HDO101 TSEMP DVX
HDO101 is an RF measurement switch. This switch module has two inputs with RF wideband detectors and one output.
About
This connector is used to control and monitor the HDO101 module using the DVX bus.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.28 |
Installation and creation
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the Moxa connected to the DVX bus, e.g., 10.11.12.13.
- IP port: The port of the local TCP connection used by the Moxa, e.g., 4001.
- Bus address: The bus address of the connected device, in the format: X.Y (where X = Rack Number, Y = Slot Number).
Usage
General page
On this page, you can find general information and statistical information (uptime, temperature, etc.) on the module.
Click the Alarm Limits page button to view or configure the analog and discrete alarm limits.
Switch
This page displays the Input 1 and Input 2 Measured RF Power, together with their Power Reference, which can be set with the Store As Reference button.
You can also configure the Routing Mode and Status Switch on this page.
Click the Normalized Values page button to configure the normalized value of the RF parameters. With the Normalize button, you can copy the current values to the normalized RF parameters.