Teleste HDO151
The HDO151 is an optical switch. The Teleste HDO151 connector can be used to display and configure information of the related device.
A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Connection – Main
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the HDO151 device.
- IP port: The IP port of the HDO151 device.
How to Use
The connector uses serial commands to request and push information to and from the node. This communication can be seen in the Stream Viewer.
The element using the HDO151 connector has a General, Monitoring, and Adjustment page.
On the General page, you can find all the details related to general information about the device, and you can set the device name.
The Monitoring page contains two tables for both analog and discrete alarm limits. You can configure those two tables.
The Adjustment page contains the most important parameters. Here, you can adjust parameters related to signal transmission.