Teleste HDO421 TSEMP
The HDO421 is an RF return path amplifier with a single input that supports frequencies from 5 MHz to 300 MHz. It provides a fixed gain with one output port. The module has a front panel RF test point. A high isolation narrowcast input with separate adjustments allows convenient realizing of narrowcast segments. The amplifier is mechanically compatible with HDX002 and HDX003 installation frames.
A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [Obsolete] | Initial version. | - | - |
| 2.0.0.x [SLC Main] | Full refactor. | - | Full refactor. |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 2.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 2.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Connection – Main
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the HDO421 device.
- IP port: The IP port of the HDO421 device.
How to Use
The connector uses serial commands to request and push information to and from the node. This communication can be seen in the Stream Viewer.
The element using the HDO421 connector has several data pages:
On the General page, you can find all the details related to general information about the device, and you can set the device name.
The Monitoring page contains two tables for analog and discrete alarm limits. You can configure those two tables.
The Adjustment page contains the most important parameters. Here you can configure the amplifier.