Teleste HDO611 TSEMP DVX

HDO611 is a wideband amplifier. It is installed into an HDX installation frame and can be used as a general gain block in headend and hub systems.

About

This connector is used to control and monitor the HDO611 module using the DVX bus.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• IP address/host: The polling IP of the Moxa connected to the DVX Bus, e.g., 10.11.12.13.
• IP port: The port of the Local TCP connection used by the Moxa, e.g., 4001.
• Bus address: The bus address of the connected device, in the format: X.Y (where X = Rack Number, Y = Slot Number).

Usage

General page

On this page, you can find an overview of the module, along with statistic information (uptime, temperature, etc.).

Click the Alarm Limits page button to view or configure the analog and discrete alarm limits.

RF

This page displays the Attenuator and Equalizer values.

Click the Normalized Values page button to configure the normalized value of the Attenuator and Equalizer. With the Normalize (All) button, you can copy the current values to the normalized parameters.