Teleste HDO613 TSEMP DVX
The HDO613 is a wideband amplifier. It is installed into an HDX installation frame and can be used as a general gain block in headend and hub systems.
About
This connector is used to control and monitor the HDO613 module using the DVX bus.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the serial gateway connected to the DVX Bus, e.g., 10.11.12.13.
- IP port: The port of the Local TCP connection used by the serial gateway, e.g., 4001.
- Bus address: The bus address of the connected device, in the format X.Y (where X = Rack Number, Y = Slot Number).
Usage
General page
On this page, you can find general information and statistical information (uptime, temperature, etc.) on the module.
Click the Alarm Limits page button to view or configure the analog and discrete alarm limits.
RF
This page displays the Attenuator and Equalizer values.
Click the Normalized Values page button to configure the normalized value of the attenuator and equalizer parameters. With the Normalize (All) button, you can copy the current values to the normalized parameters.