Teleste HDP301 TSEMP
The HDP301 is a switched‐mode power supply module for the HDO optical headend platform. The Teleste HDP301 TSEMP connector can be used to display and configure information of this device.
A serial connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [Obsolete] | Initial version. | - | - |
| 2.0.0.x [Obsolete] | Full refactoring. | - | Elements should be recreated. Alarm and trend templates should be recreated. |
| 2.0.1.x [SLC Main] | Standalone measurement parameters are now shown in a table. | 2.0.0.2 | Alarm templates, trend templates, and automation scripts for this connector should be remade. |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 2.0.0.x | - |
| 2.0.1.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 2.0.0.x | No | Yes | - | - |
| 2.0.1.x | No | Yes | - | - |
Configuration
Connections
Serial Connection – Main
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the HDP301 device.
- IP port: The IP port of the HDP301 device.
How to Use
The connector uses serial commands to request and push information to and from the node. This communication can be seen in the Stream Viewer.
The element using the HDP301 connector has several data pages:
On the General page, you can find all the details related to general information about the device, and you can set the device name.
The Monitoring page contains two tables for analog and discrete alarm limits. You can configure those two tables.
The Measurements page contains HDP301 power measurements. It also keeps track of peaks.