Telos Alliance iPort
The Telos Alliance iPort is an audio gateway. This connector can be used to monitor and control this device.
About
The connector uses SNMP and serial communication (based on the Livewire protocol) to retrieve information from the device.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.1.0j |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Serial "Serial Connection" Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- Direct connection:
- Baudrate: Baudrate specified in the manual of the device.
- Databits: Databits specified in the manual of the device.
- Stopbits: Stopbits specified in the manual of the device.
- Parity: Parity specified in the manual of the device.
- FlowControl: FlowControl specified in the manual of the device.
- Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage
General
This page displays general information on the device.
Source page
This page contains the Sources table, with stream status and stream address information.
Encoder page
This page contains the Encoder table, with information on the input gain, address, source name, number of channels, operational state, receive state and audio state.
V-Mixer/V-Mode page
This page contains the VMix and VMode tables, with information on the input gain, address, source name and number of channels.
Meter Data page
This page contains the Input MTR and Outputs MTR tables, with their respective PEEK and RMS values.
Input Detection and Output Detection pages
These pages allow you to configure the clip and silence level of the available channels.