Telos Systems Omnia.9
This standard configuration offers processing for FM or AM, with optional and simultaneous processing for HD-1, HD-2 and HD-3. Each HD source can also be independently processed and encoded for stream audio. FM and AM transmitters can be processed simultaneously, if the FM and AM stations are 100% simulcast and from the same transmitter site.
About
This connector monitors general status parameters of the device and input status parameters of 4 inputs.
SNMP is used to retrieve the device information. SNMP traps can be retrieved when this is enabled on the device.
In connector range 1.0.1.1, an additional HTTP connection is used to read and write device information.
Version Info
| Range | Description |
|---|---|
| 1.0.0.x | Initial version |
| 1.0.1.x | Added HTTP connection |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
| 1.0.1.x | ≥ 3.19.51 |
Configuration
Creation
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: Not required.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, i.e., public.
- Set community string: The community string used when setting values on the device, i.e., private.
HTTP Connection [range 1.0.1.x]
This connector uses a secondary HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
TCP/IP Settings:
- IP port: The port of the connected device, by default 7380.
- Bus address: By default bypassproxy.
Usage
Status
This page contains input status parameters.
Preset
This page contains preset parameters (Input, FM, HD, Stream, Studio).
RDS [Range 1.0.1.x]
This page contains Radio Data System (RDS) parameters (e.g., UECP, Radiotext).
FM Options [Range 1.0.1.x]
This page contains parameters for FM Options.
Web Interface [Range 1.0.1.x]
This page provides access to the web interface of the device. The web interface is only accessible when the client machine has network access to the product.