Telos Systems Omnia.9sg
The Omnia.9sg is based on the same limiter, clipper, and stereo generator technology incorporated in the Omnia.9 and is ideal for applications where the final limiter and stereo generator must be separate from the main audio processor.
This connector monitors specific Omnia parameters as well as general status parameters via HTTP. SNMP traps can be retrieved when this is enabled on the device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
Configuration
Connections
HTTP connection
This connector uses an HTTP connection to receive traps and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
- Port number: The port of the device.
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection to receive traps and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: Not required.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, i.e., public.
- Set community string: The community string used when setting values on the device, i.e., private.
How to use
The element consists of the data pages detailed below.
General
Contains parameters related to the stereo generator.
System
Provides information related to the performance and configuration of 9sg, including CPU data, software versions, network information, the Monitor Out status and a list of current alarms.
The System Configuration page button displays the current 9sg software and NfRemote client version. With the Reinstall button, you can reinstall the currently loaded software version. The Save Configuration to USB button saves the current configuration to USB.
Audio Info
Displays information about the digital and analog input signals.
MPX
Displays general MPX parameters and parameters related to MPX1 and MPX2.
RDS
Displays parameters related to RDS.