Teracue ENC-300

The ENC-300 encoder is designed for IPTV and live streaming.

About

The Teracue ENC-300 connector is used to monitor and control a Teracue ENC-300 device. The information is spread over different pages to resemble the web interface of the device as much as possible.

Installation and configuration

Creation

SNMP CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• Device address: Not used.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

Overview Page

The General page displays general information about the device.

Setting page

The Encoder page displays the encoder settings. The user can modify some of these values.

Video page

On this page, the settings for video can be viewed and modified as preferred.

Audio page

On the Audio page, the settings for audio can be viewed and modified as preferred.

Output page

On the Output page, the Transport Protocol and the FEC parameters can be viewed and modified. Below them, the Destination Table is displayed.

GPIO page

On this page, the GPO Value can be viewed and set, and the GPI Value can be viewed.

Webpage

This page displays the webpage of the device.