Terrasat Communications IBUC
The Terrasat Communications IBUC is a highly advanced intelligent BUC with special custom features such as low phase, built-in M&C and increased RF efficiency with integrated fully automatic gain control and ALC.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
| 2.0.0.x | New connector range due to firmware version change | 1.0.0.11 | - |
| 2.0.1.x [Obsolete] | Mandatory changes due to firmware version change | 2.0.0.8 | The parameter descriptions "DC Voltage" (105) and "DC Current" (107) have been changed to "Supply Voltage" and "Supply Current". If these parameters are used in a script (GetParameter by name), make sure to update the referenced names in the script. |
| 2.0.2.x [SLC Main] | Added DCF Support, RF In and RF Out | 2.0.1.3 | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 2.0.0.x | - |
| 2.0.1.x | FW IBR v5.19 |
| 2.0.2.x | FW IBR v5.19 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 2.0.0.x | No | Yes | - | - |
| 2.0.1.x | No | Yes | - | - |
| 2.0.2.x | Yes | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the Main View and General page, you can find monitoring parameters such as Input Power Level, Output Power Level, Supply Voltage and Supply Current.
On the Transmitter page, you can configure the Attenuation, Gain Mode, Burst Timeout and other parameters.