Tredess Redundant Clock Reference
The Tredess redundant clock reference provides high-stability frequency and time reference signals. This unit manages, integrated into the same chassis, two synchronization modules with a built-in OCXO and GNSS receiver with 1+1 redundancy.
The Tredess redundant clock reference connector shows status information of the device and can be used to configure the device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 01.V01 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
How to use
On the General page of this connector, you can configure the datetime settings and view the control board temperature.
The pages Network Interfaces, SNMP Settings, SNMP Traps, I/O Interface, Event Configuration, Device Info, PTP Master and Power Supply all contain information about the device.
The pages Synchronization Modules, PTP Slaves, OCXO, GNSS Receivers, GNSS Antenna Jamming, Constellations, Satellites and Satellites Details all contain information about the synchronization modules.
The Switching page allows you to configure the settings for switching between the two synchronization modules.
The Status page contains a list of alarms used by the device itself.