TrippLite ATS Switched PDU WEBCARDLX

The PDU line of devices from TrippLite allow for the use of multiple outlets, but does not guard against surge or line noise protection for connected equipment.

About

The TrippLite ATS Switched PDU WEBCARDLX connector allows for configuration and monitoring of several ATS and EnviroSense devices.

Version Info

Range	Key Features	Based on	System Impact
1.0.0.x [SLC Main]	Initial version	-	-

Product Info

Range	Supported Firmware
1.0.0.x	15.5.1

System Info

Range	DCF Integration	Cassandra Compliant	Linked Components	Exported Components
1.0.0.x	No	Yes	-	-

Installation and configuration

Creation

SNMP main connection

This connector uses a Simple Network Management Protocol (SNMP) version 3 connection and requires the following input during element creation:

SNMP CONNECTION:

IP address/host: The polling IP of the device.

SNMP Settings:

Port number: The port of the connected device, by default 161.
Security level and protocol: The level of security used for the SNMPv3 communication, either no authorization or privacy (noAuthNoPriv), authorization but no privacy (authNoPriv), or authorization and privacy (authPriv).
User name: The user name used for the connection with the device.
Authentication password: The password used during the authorization process.
Encryption password: The password used for decryption private information
Authentication algorithm: The algorithm used for the authentication.
Encryption algorithm: The algorithm used for the encryption.

Usage

General Page

This page displays all the generic information of the connected devices, including the number of ATS Devices and EnviroSense Devices.

The Devices table allows for monitoring of the different devices and configuration of the Name, ID, Location, and Region.

ATS Page

All of the information regarding the ATS devices can be found using this page.

The ATS Device Info table contains mostly the status of the ATS device but also allows for commanding the Main Load and the configuration of the Power On Delay.

The ATS Display Info table allows for configuration of the ATS Scheme, Orientation, Auto Scrolling, Intensity, and Units.

The ATS Identity Info table displays the amount of connections to the ATS, including the Inputs, Outputs, and Outlets.

Using page buttons, the following can be accessed:

Outlets: contains information on the ATS outlets in the Outlets and Outlet Groups tables.
Inputs: contains information on the ATS inputs in the Inputs and Input Phase Info tables.
Outputs: displays the Outputs table with data on the outputs of the ATS.
Breakers: displays the Breakers table with data on the breakers of the ATS.
Heat Sinks: displays the Heat Sinks table with data on the heat sinks of the ATS.
Circuits: displays the Circuits table with data on the circuits on the ATS.
Supports: displays the ATS Supports table with the various supported functions of a ATS.
Controls: allows the user to run several commands via buttons in the Controls table.
Configuration: displays the Configuration and Threshold Config tables which allow the user to configure the device source and threshold information.
Voltage Ranges: displays the Voltage Range Config and Voltage Range Limits table with configuration parameters for the ATS voltage ranges.

EnviroSense Page

All of the information regarding the EnviroSense devices can be found using this page. Polling of the EnviroSense information can be enabled or disabled using the Poll EnviroSense Info toggle button.

The EnviroSense Identity Info table displays if the Temperature and Humidity is supported and the number of Input and Output Contacts.

The EnviroSense Configuration table allows for configuration of the Temperature and Humidity Limits.