Vertex RSC-1200

About

This connector allows you to monitor the Vertex RSC-1200 SWO device.

Product Info

Range	Supported Firmware
1.0.0.x	3.00 2.12

Configuration

Connections

Serial Main Connection

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• Direct connection:

  • Baudrate: Baudrate specified in the manual of the device.
  • Databits: Databits specified in the manual of the device. (default: 8)
  • Stopbits: Stopbits specified in the manual of the device. (default: 1)
  • Parity: Parity specified in the manual of the device. (default: no)
  • FlowControl: FlowControl specified in the manual of the device.

• Interface connection:

  • Type of port: TCP/IP
  • IP address/host: The polling IP of the device.
  • IP port: The IP port of the device.
  • Bus: the bus address, in case of any (Range: 0 - 255)

How o Use

General Page

This page contains general information about the device such as Power Supply and Unit Current. Here you can also find page buttons to the Controller Alarms, Switch Control and the Event Log.

Configuration Page

This page displays configurable parameters such as Redundancy Mode, Remote Control, Noise Diode, etc.

Internal/External Input Alarms Page

This page displays the Alarm Statuses of the device.