Vertiv EXL S1

About

The Vertiv EXL S1 connector enables data integration and monitoring of Vertiv's high-efficiency uninterruptible power supply (UPS) system, the EXL S1 series. This connector retrieves operational and performance data via SNMP from the UPS, including parameters such as input/output voltage, battery status, bypass, alarms, and configuration. The source of the data is the UPS's SNMP interface, which must be correctly configured and reachable on the network.

Configuration

Connections

SNMP Connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP or URL of the destination.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string used when reading values from the device (default: public).
• Set community string: The community string used when setting values on the device (default: private).

Web Interface

The web interface is only accessible when the client machine has network access to the product.

How to Use

General Page

On the General page, system information and battery information are available. This includes the firmware version, device name, battery status, battery charge, and more.

Inputs, Outputs, and Bypass Pages

These pages contain information regarding the inputs, outputs, and bypass, respectively, allowing you to monitor the voltages, currents, power, and frequencies of the device.

Alarms Page

Any alarms thrown by the UPS are shown on the Alarms page. The status of certain well-known alarms can be found on the Well-Known Alarms subpage.

Configuration Page

Any information regarding the configuration of the device, such as the nominal voltage and nominal frequency, can be found on the Configuration page.

Notes

For this connector to be able to poll data, SNMP must be configured on the device.