ViaSat VPCMA
This connector is used to monitor the ViaSat VPCMA device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.1.7 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device (default value: public).
- Set community string: The community string used when setting values on the device (default value: private).
Initialization
No extra configuration is needed.
Redundancy
No extra configuration is needed.
How to Use
The connector uses the SNMP protocol to retrieve data from the device.
The General page lists the device info and the main status parameters (Lock, SNR, etc.).
On the Setup page, you can modify the settings of the device (Cancellation Bandwidth, Output Power Mode, etc.).
On the Diagnostics page, you can run tests on the device. Three kinds of tests are available: Built-in Test, Continuous Wave and Pass Through.
The Alarms page lists all the alarms active on the device.
The Traps page contains the Traps Table, which lists the most recent traps received by the device.