Viaccess CAS
This connector can be used to monitor the Viaccess CAS, a conditional access system that can be used in digital video broadcasting.
About
This connector can only be used for monitoring purposes. It only performs SNMP Gets and receives and processes traps.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page shows general information about the ECMG, EMMI, EXMC and SIM.
With the Polling Time parameter, you can configure the polling time of the parameters.
The page also contains page buttons that provide access to additional information:
- ECMG-SCH: This subpage displays general information and errors.
- ECMG-SCS: This subpage displays general information and errors.
- ECMG-CS: This subpage displays general information and errors.
- SIM ECMG: This subpage contains a table with general information and errors.
- SIM ECMG-C: This subpage contains a table with general information and the errors and delays for each channel.
- SIM ECMG-S: This subpage contains a table with general information and the errors for each stream.