Viaplay SCTE Injector
Viaplay SCTE Injector is a connector designed to facilitate the manual injection of SCTE 35 messages into live streams.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial connection
This connector uses a serial connection, and requires the following input during element creation.
SERIAL CONNECTION:
Interface connection:
- IP address/host: You can enter an arbitrary IP address, because it will be overwritten when the element is started. You will be able to select a device, and the IP address will then be dynamically updated.
- IP port: You an enter an arbitrary port, because it will be overwritten when element is started. You will be able to select a device, and the port will then be dynamically updated.
How to use
General
This page displays basic information about the available devices, including the device name, IP address, and port.
Management
In the Management table on this page, you can select a device and set the duration of an interruption. Use the Take button in the table to send an interruption command, or use the Stop button to halt the interruption or to stop an interruption if it started by mistake.
The timestamp of the last use of the Take command is also displayed.