Table of Contents

WISI LX10

With this connector, information from the device WISI LX10 can be gathered and viewed, and values can be set on the device.

About

Connector used to gather information from the WISI LX10 device.

The connector has several pages with general information, alarms, power supply, transmitter information, etc.

Installation and configuration

SNMP Connection

  • IP address/host: The polling IP of the device, e.g., 172.27.64.55.
  • Device address: Not needed.

SNMP Setting

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General

This page displays some general information about the device, such as the firmware version, device type, uptime, vendor information, etc.

Power Supply

This page shows information regarding the power supply, as well as the status of the cooling fans.

Transmitter Data

This page displays information regarding the transmitter: general transmitter information, laser information, CATV information, optical information, satellite information and voltage information.

Unit alarms

This page displays the status of the transmitter alarms: the System Temperature, Laser current, Optical Power, etc.

The following page buttons are also available:

  • Alarm Log.
  • System Status Enable.
  • History Alarms.

Misc alarms

This page displays the status of miscellaneous alarms: the 2GHz Power, System Power, Communications Failure, etc.

The following page buttons are also available:

  • Alarm Log.
  • Misc Status Enable.
  • Misc History Alarms.

Front Panel

This page shows the front panel status.

Configuration

On this page, you can view and set the device configuration:

  • Network Setting
  • Remote Configurations
  • SNMP Settings

Through two page buttons, Trap Configuration. and Alarm Thresholds., you can configure the trap settings and the alarms thresholds.

Web Interface

This page shows the device web interface.

A user name and password are required to access this page.

Improve this page