WISI Tangram GT23

The WISI Tangram GT23 connector is used to monitor and control the Tangram GT 23 W module. The GT 23 W module allows you to add up to 8 services in QAM (DVB-C) format per module to your network.

About

This connector is automatically generated by connector WISI Tangram range 1.0.0.x, 1.0.1.x, 1.1.0.x, and 1.1.1.x.

Product Info

Range	Supported Firmware Version
1.0.0.x	1.00.0.00
1.0.1.x	1.00.0.00 2.3
1.1.0.x	1.00.0.00 2.3
1.1.1.x	1.00.0.00 2.3
1.2.0.x	3.5.2

Installation and configuration

Creation

This connector is used by DVE child elements that are automatically created by the connector WISI Tangram.

Usage

General

This page contains general information, such as the DVE Name, Type, HW Version and Communication Status, which displays if the module is Ok or in Timeout, or if the wrong IP address is configured.

Input/Output

Every supported module type of the Tangram has an Input and Output table.

Service Management

This page contains a table listing the services of the card.

Service Overview

This page contains a tree overview of the current services and their streams.

Networking

This page contains the settings for the management interfaces for the GT11. All IP traffic for GT11 management occurs via the Management port.

SNMP

This page allows you to manage the SNMP settings.

HMS

On this page, you can manage groups of modules. Modules included in the same group can share PSI/SI information to be able to create correct DVB network-wide PSI/SI structure.

Date and Time

This page allows you to connect to time reference sources for the GT11.

Logging

This page displays log information.

Webpage

This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.