Wellav UMH 160 IP-S2
The Wellav UMH 160 IP-S2 connector can be used to display information of any related device.
About
This protocol can be used to monitor the Wellav UMH 160 S2 and WellAV UMH 160 IP devices. WellAV UMH 160 T2 devices are monitored by a separate protocol.
An SNMP connection is used to successfully retrieve the device's information.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is public.
Usage
The connector contains 10 pages.
Status
This page displays all status information for the Input Tuner, Input ASI, Input IP, Decoder, Output ASI, Output IPs and CI Slots.
Programs
The page contains the Program Table with the Program Names and Program PIDs. Two buttons allow to Scan TS for DVB and ATSC.
The Source Select, the T2MI and Bypass Whole Stream for ASI and IP can also be set on this page.
Input Receiver
This page displays the Satellite Frequency, Symbol Rate and LNB Frequency, Power Supply and 22KHz.
Input IP
This page displays the following local connection and channel information.
- Local IP Address
- Local Subnet Mask
- Local Gateway
- Local Speed Mode
- Local Mac
- Channel
- Source IP Address
- Source Port
- Protocol
A page button opens the IGMP page, which displays the IGMP Version, Auto Report, Filter and IP Address.
Output Decoder
This page displays information related to the decoder, video, audio, subtitle and teletext. The related tables display the indexes, names and PID.
Output ASI
This page displays the Constant Rate.
Output IP
This page provides the GbE Port-Setting for the Main and Backup and the following IP information for the three channels:
- Enable
- Protocol
- IP Address
- Port
- Backup IP Address
- Backup Port
CA
This page shows the CAM Max Bitrate and BISS related parameters: Mode, the BISS-1 and BISS-E Keys and the BISS-E ID.
System
This page displays system information such as the IP Address, Subnet Mask and Gateway, as well as some Trap information. This page also contains a Reboot and a FactorySet button.
Alarm
This page displays six alarms: LNB Connection Short, Signal Unlock, CAM 1 and CAM 2 Communication Error and Descrambling.
Web Interface
On this page, you can view the web interface of the device. However, the client machine has to be able to access the device. Otherwise, it will not be possible to open the web interface.