Witbe Management System
This connector displays the traps of the Witbe Management System.
About
This connector is able to receive all traps of the Witbe Management System and display them in a table.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection to receive traps and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is private.
Usage
General
This page displays the received traps in the measurement table.
Measurements with a duration of 0 can be removed with the Remove Unused Meas. button.