Table of Contents

Work Microwave Redundancy Switch Controller Converter

The Redundancy Switches from WORK Microwave are utilized to provide redundant configurations with automatic or manual switchover for subsystem using Upconverters, Downconverters, or Modulator-Upconverters from WORK Microwave or similar equipment.

About

With this connector, it is possible to monitor and configure Work Microwave Redundancy Switch Controller Converter devices with a serial connection.

The different parameters from the device are displayed on multiple pages. Specific parameters for the converters are displayed by the converter connector.

Installation and configuration

Creation

When creating the element the device IP address, the port and the bus address should be filled in. for the bus address, use the bus address of the Redundancy Switch Controller followed by the unit, separated with a dot. For example : 66.1

Usage

General

This page displays general System Information of the converter.

With the page button, It is possible to change some general configuration.

This page allows the user to view and change settings about the UPC module such as:

  • Current/Minimum Attenuation
  • Deep Fade Settings
Improve this page